Once the pressure tank is filled,

[zihadhosenjm40]

Connection to water pipes is performed using flexible adapters. It should be remembered that the diameter of the adapters must correspond to the dimensions of the water pipes; narrowing is unacceptable. Before filling the tank with water, all air should be removed from the membrane.

To dampen vibrations that occur during operation of the hydraulic accumulator, special flexible hoses of the appropriate diameter are used when connecting the device to the water supply system.

The first time, water is pumped in as slowly as possible, in a thin stream with low pressure. This is necessary so as not to damage the membrane, which could have compacted or deformed slightly during storage in the warehouse.

Such nuances may seem trivial, but they can significantly affect the condition of the hydraulic tank. An important point is also the adjustment of the pressure in the tank.

After the hydraulic accumulator is filled with water, you need to lebanon mobile database the air pressure again. The less air in the hydraulic tank, the lower its pressure, the greater the volume of water that can be pumped into it. But the less air, the lower the working pressure of the water at the outlet of the hydraulic accumulator.

It is permissible to reduce the air pressure in the device to a level of 1 bar if there is a need to create an additional volume of water for storage. However, this will reduce the water pressure in the system. The owner of the device will have to choose between good pressure and the ability to pump a large volume of water into the tank.

In any case, the minimum air pressure value should be 1 bar. If there is little air in the tank, the membrane insert filled with water will stretch and may touch the metal walls of the hydraulic tank. Such contact is unacceptable, since under its influence the rubber will begin to deteriorate, the hydraulic accumulator will break, and the membrane will have to be replaced.

Image Gallery Photos from Working in tandem with a pressure switch Pressure switch installation location Dry running switch location Equipment preservation crane

set up and connected to the plumbing system, the pressure switch can be adjusted. It usually comes with instructions detailing the procedure.

There are two adjustment springs under the device housing cover. The large spring, marked as P, allows you to set the minimum pressure at which the relay turns on the pump and starts pumping water into the hydraulic accumulator.