Knitting methods and patterns

[zihadhosenjm40]

special handle. It has a screw thread cut into it, and inside there is a spring responsible for returning the hook to its original position.

The ends of the wire are hooked, and the device must be pulled from the connection point. The rod begins to rotate along the spiral grooves, rotating relative to its axis. This is how the twisting occurs.

In fact, a tool with a chuck works in exactly the same way. For example, a screwdriver. That is, the hook can be inserted into the chuck of the screwdriver and the latter can be turned on. The rotational doctor data will create a twist of wire. This method is often used by craftsmen.

This device belongs to the category of special tools, because it is intended for only one action. The design of this power tool inserts spools of wire (they are replaceable). That is, the device itself pushes out the wire, and knits it itself according to a certain pattern. Convenient, fast, high-quality, but expensive in terms of the price of the gun.

Its only drawback is that it requires electricity either for direct connection or to recharge the batteries.

Tying a foundation frame manually is not as easy as it may seem at first glance. It is a labor-intensive task that requires a lot of time. But among all the schemes there are simple options. Here is one of them.

A piece 25-30 cm long is cut from the wire coil.
It folds in half.
Wrapped around the junction of two rods.
The hook is used to catch the loop that needs to be rotated.
One end of the wire is added to the twist after two turns.
After two more turns, the second one.
A complete twist is carried out.
The tool for tying the reinforcement according to this scheme - the hook - should rotate until the wire binding becomes tight. But you should not over-twist it, as this will weaken the wire material itself.