This installation method is used to create an unusual interior design.
Posted: Thu Feb 06, 2025 6:37 am
Docking at an angle of 45˚
When installing, it is impossible to do without trimming the areas where individual parts of the kit are connected. Trimming at an angle of 45˚ is used most often. It is ideal for any type of finishing, successfully hiding the saw cut areas.
45˚ jointing hides cut areas
Docking at 90˚
The trims are joined at a 90 degree angle. The top trim board is placed between the right and left parts.
Docking at 90˚
90˚ joint with imitation of a lintel
Great for historical imitation
Installation of wooden or MDF door frames with cut ends at an angle of 45°
Step 1. Preparing the surface of the doorway and door frames
Using a construction knife, carefully cut egypt mobile database the protruding mounting foam, being careful not to damage the door frame when cutting. Be especially careful when working around the visible corners of the frame, which are covered with self-adhesive polyethylene film.
Carefully cut off the foam
Check the position of the wall plane and the frame. Take a level strip and check the position of the wall and frame along the entire perimeter of the doorway. If there are problems, you will have to solve them during the installation of the casings. We will tell you how to do this below. The ends of the lower part of the casings need to be cut off - they could be damaged during transportation or long-term storage.
For one door you will need four long and two short trims. You need to saw off with a length reserve of 3÷4 centimeters.
Step 2: Mark the position of the trims
The door frame has rounded corners, a right angle only on the extension side. We recommend installing the door frames so that the rounding is not covered. On the extension side, the corners of the door frame should match the corners of the extension exactly.
We mark the position of the casing
When installing, it is impossible to do without trimming the areas where individual parts of the kit are connected. Trimming at an angle of 45˚ is used most often. It is ideal for any type of finishing, successfully hiding the saw cut areas.
45˚ jointing hides cut areas
Docking at 90˚
The trims are joined at a 90 degree angle. The top trim board is placed between the right and left parts.
Docking at 90˚
90˚ joint with imitation of a lintel
Great for historical imitation
Installation of wooden or MDF door frames with cut ends at an angle of 45°
Step 1. Preparing the surface of the doorway and door frames
Using a construction knife, carefully cut egypt mobile database the protruding mounting foam, being careful not to damage the door frame when cutting. Be especially careful when working around the visible corners of the frame, which are covered with self-adhesive polyethylene film.
Carefully cut off the foam
Check the position of the wall plane and the frame. Take a level strip and check the position of the wall and frame along the entire perimeter of the doorway. If there are problems, you will have to solve them during the installation of the casings. We will tell you how to do this below. The ends of the lower part of the casings need to be cut off - they could be damaged during transportation or long-term storage.
For one door you will need four long and two short trims. You need to saw off with a length reserve of 3÷4 centimeters.
Step 2: Mark the position of the trims
The door frame has rounded corners, a right angle only on the extension side. We recommend installing the door frames so that the rounding is not covered. On the extension side, the corners of the door frame should match the corners of the extension exactly.
We mark the position of the casing