Fuel injection pump repair
The engine is the most important part of any mechanism, but it often does not start for some reasons, for example, when there are problems with the fuel pump. It works as long as fuel enters the pump, when this does not happen, the pump breaks. In this case, it is necessary to urgently inspect, disassemble, clean and fix all the violations. It is possible that the pump is dirty, then it should be cleaned and installed in place.
Important! If you have a two-stroke engine and you use a gasoline-oil mixture, you must flush the entire fuel system with clean gasoline.
of the breakdown may be poor operation of the unit. There may also be a problem with the ignition, here you should check the spark plugs and if they are faulty, then you need to install new ones.
If the engine is running with a knock, the reason may be damage to one of the internal parts (cylinder, bearing, piston, perhaps a ring has come off the piston). Here, repairs involve replacing faulty parts with new ones.
The cultivator motor may also make a humming noise. The problem may be an overheated engine or the use of low-quality fuel. In this case, it is recommended to work at a slightly lower speed or replace it with high-quality gasoline.
If the cultivator paws (cutters) do not work, then most oman mobile database this indicates that something is stuck between them and does not allow the engine to continue to work normally. If not, then it is worth checking the following parts: fastening, pulley, position of the intermediate gear and drive belt. If so, then you just need to change this element or install a new one, this can be done with everything except the pulley. It cannot be repaired independently, you should take it to the service.
Attention! Very often, problems are not in the breakdown of this or that element, but in ordinary contamination, so always immediately before working with a motor cultivator, you need to check all the parts for cleanliness and serviceability. After all, most often, simple clogging entails many serious problems and breakdowns.
If there are problems with the gearbox, and reverse gear does not work normally, then you need to check the serviceability and integrity of this part, because often the cause of the breakdown is the age of this element. Then you need to replace not only the gearbox itself, but also the reverse.
If there are problems with the ignition system, then first you need to check the fuel by unscrewing the spark plug. If it is wet, then it is coming. You also need to check for a spark between the electrodes, if there is none, then look for a breakdown in the generator chain.
If the engine power is losing its strength, then it is necessary to check the carburetor, fuel hose and air filter, because problems with these parts often occur due to their clogging or contamination.
If your motor cultivator has no compression, you need to check and replace the cylinder, piston and piston rings.
The engine may also stall, then the cause
-
- Posts: 523
- Joined: Sat Dec 21, 2024 3:31 am